Download Steering Column Shroud Ignition Switch Lock Cylinder Screw (2 Req’d) Turn Signal and Windshield Wiper Switch Tilt Wheel Handle and Shank Steering Column Shroud-Lower Screw (3 Req’d) Tighten to 2.1-2.9 Nm (19-25 Lb-In) Tighten to 3.5-5 Nm (31-44 Lb-In) Tighten to 0.6-1.1 Nm (7-10 Lb-In) 5. Remove four bolts and instrument panel steering column cover (04459) from under steering column tube. 6. Remove steering column shroud (3530) . Disconnect all electrical connections from turn signal and windshield wiper switch (13K359) . 7. Remove two screws retaining turn signal and windshield wiper switch and remove turn signal and windshield wiper switch. 8. Pull transmission selector lever arm and support to the full down position (column shift). 9. Remove four (Taurus), five (Sable) instrument panel finish panel retaining screws. 10. Remove instrument panel finish panel by pulling toward driver to unsnap snap-in retainers and disconnect wiring from switches, electric clock (15000) and warning lamps. 11. To install, reverse Removal procedure.