Home Tips & Tricks 2000 Volkswagen Jetta Transmission, Disassembling And Assembling

2000 Volkswagen Jetta Transmission, Disassembling And Assembling

66
Download 1. 2. 3. 4. 5. 6. 1st gear 2nd gear 3rd gear 4th gear 5th gear Transmission housing Servicing. Refer to Case, M/T. 7. Selector mechanism (Selector forks) Disassembling and assembling. Refer to Shift Fork, M/T. 8. Input gear for 1st and reverse gear 9. Input shaft Disassembling and assembling. Refer to Input Shaft. 10. Output shaft Disassembling and assembling. Refer to Output Shaft, M/T. 11. Differential Disassembling and assembling. 12. Clutch housing Servicing. Assembly Overview I – Removing and installing cover for transmission housing and 5th gear. II – Disassembling and assembling transmission housing and shift mechanism. III – Disassembling and assembling input shaft, output shaft, differential and selector forks. Transmission Housing And 5Th Gear Cover, Removing And Installing Cover 1. Bolt, 10 Nm (7 ft. lbs.) For transmission housing cover 2. Transmission housing cover Note: If the transmission cover IS removed and reinstalled with the transmission installed, check oil level as follows: Fill with oil up to lower edge of filler hole and install filler plug. Start engine, engage gear and allow transmission to turn for approx. 2 minutes. Switch off engine and top up transmission oil to lower edge of filler hole again. 3. Gasket 4. Torx socket head bolt M10, 80 Nm (59 ft. lbs.) Bolt head holds dished washer in position 5. Dished washer Installing. Refer to Case, M/T. 6. Socket head bolt, 25 Nm (18 ft. lbs.) For pivot pin to transmission housing 7. Pivot pin 8. 5th gear selector fork Disassembling and assembling Adjusting.