Home Tips & Tricks 1998 Volkswagen New Beetle Front door trim removing and installing

1998 Volkswagen New Beetle Front door trim removing and installing

76
Download CAUTION: Before working on electrical system: Disconnect battery ground (GND) strap –> 27 – BATTERY, STARTER, GENERATOR, CRUISE CONTROL, MECHANICAL COMPONENTS, TROUBLESHOOTING NOTE: Removal and installation is described for right side of vehicle. The same instructions apply for removal and installation for the left-hand side. Obtain security code for radio with anti-theft coding before disconnecting battery Ground (GND) strap Removing Switch ignition off. Disconnect battery ground (GND) strap –> 27 – BATTERY, STARTER, GENERATOR, CRUISE CONTROL, MECHANICAL COMPONENTS, TROUBLESHOOTING Removing handle trim Insert flat screwdriver between handle trim – 1 – and handle and carefully press handle trim off door trim Removing window crank handle Slide spacer ring – 1 – in – direction of arrow – (securing clip is released) and pull window crank from mechanism. Remove three bolts – arrows -. Unclip door trim – 1 – at the sides using Pliers 3392. Lift door trim upward out of window recess seal. Unclip cable guide – 1 – using a flat screwdriver – 2 – , pull out bracket – 3 – in – direction of arrow – and unhook cable hook – 4 -. Disconnect harness connectors. Installing Installation is performed in the reverse order of removal. NOTE: Before installing door trim, check clips and replace if necessary, and insert into mounts of door trim. After connecting battery, vehicle options