Home Tips & Tricks 1997 Toyota Camry LE Sedan Power Steering Pump: Service and Repair Installation

1997 Toyota Camry LE Sedan Power Steering Pump: Service and Repair Installation

58
Download 1. Install pressure feed tube. a. Torque the union bolt with a new gasket to 52 Nm (38 ft. lbs.). NOTE: Make sure the stopper of the tube is touching the front bracket, as shown, then torque the union bolt. b. Install the oil pressure switch to the union bolt, torque to 21 Nm (15 ft. lbs.). 2. Install PS vane pump assembly with pressure feed tube. Temporarily tighten the 2 (A and B) bolts. 3. Install drive belt. a. Adjust drive belt tension. b. Using Special Service Tool (SST) 09249-63010, torque the A bolt to 29 Nm (21 ft. lbs.). NOTE: Use a torque wrench with a fulcrum length of 300 mm (11.81 inch). c. Torque the B bolt to 43 Nm (32 ft. lbs.). e. Connect the connector to the oil pressure switch.4. Connect pressure feed tube. a. Using SST 09631 – 22020, connect the tube, torque to 32 Nm (24 ft. lbs.). NOTE: