Home Tips & Tricks 1999 Volvo V70 XC REPLACING TIMING BELT/ IDLER PULLEY/ BELT TENSIONER

1999 Volvo V70 XC REPLACING TIMING BELT/ IDLER PULLEY/ BELT TENSIONER

63
Download Remove components Caution! Remove the ignition key from the ignition switch before beginning Note! work. Crankshaft or camshaft must not be rotated under any circumstances more than is listed below. Failure to follow these instructions may cause damage to the valves. upper timing belt cover. servo reservoir and expansion tank. Lift up and place on top of engine. Note! Take care not to spill servo oil from the bleed hole in the cap. Place paper wipe around the reservoir and then cover with a plastic bag as protection. Spilled servo oil is highly inflammable. auxiliaries belt. front camshaft belt cover. Position engine according to marking Raise the car. Remove right front wheel. Remove the nut for the cover in the fender liner. Install the upper camshaft belt cover. Turn crankshaft clockwise until the markings on the crankshaft and camshaft pulley correspond. Turn the crankshaft a further 1/4 turn clockwise and then back again until the markings correspond. The markings are illustrated. Remove upper camshaft belt cover.