Home Tips & Tricks 2007 TOYOTA FJ CRUISER AIR DAM/LIGHT BAR Installation

2007 TOYOTA FJ CRUISER AIR DAM/LIGHT BAR Installation

66
Download 2. Interior Installation of Switch/Wire Harness (a) Locate the vehicle white 6-pin connector behind the lower instrument panel. (Fig. 2-1) (1) Note: The vehicle connector will be wrapped in gray foam tape. (b) Install the Off Road switch (Fig. 2-2) in the available knockout ( Location 1 or 2) and in the orientation shown. (Fig. 2-1) (c) Plug the white 6-pin connector into the switch. (1) Confirm the connector is securely attached. (d) Remove driver and passenger side sun visors. (1) Rotate and loosen the visor support shaft from the visor holder clips as shown. (Fig. 2-3) (2) Do not remove clips from headliner. (e) Remove sun visors (Fig. 2-4) (1) Remove the two (2) Phillips screws from driver and passenger side sun visors. (f) Remove the driver and passenger side assist grips. (1) Carefully remove the screw covers for all four (4) assist grips. (Fig. 2-5) (g) Remove the two (2) 10 mm hex head screws from driver and passenger side assist grips. (Fig. 2-6) (h) Remove front passenger side “A” pillar garnish. (1) Pull door seal down from around front pillar. (2) Disengage two (2) clips and one (1) claw and remove the front pillar garnish.