Home Tips & Tricks 1997 Ford Expedition Actuator, A/C Electronic Removal Installation

1997 Ford Expedition Actuator, A/C Electronic Removal Installation

90
Download 1. If equipped, remove the floor duct panel. Remove the two plastic push pins (one each side) and release the expander clip. 2. If equipped, remove the floor console. For additional information, refer to Section 501-12 . 3. Remove the RH instrument panel brace. 1. Remove the lower nut. 2. Remove the upper bolt. 3. Remove the brace. 4. Remove the LH instrument panel lower nut and position brace aside. 5. Remove the floor duct. 1. Remove the two screws (one each side). 2. Remove the floor duct. 6. NOTE: Rotate the vacuum control motor to disconnect the vacuum control motor rod from the panel/floor door. Remove the panel/floor door vacuum control motor (18A318). 1. Disconnect the vacuum line connector. 2. Remove the panel/floor door vacuum control motor screws. 3. Slide the rod out to the door and remove the panel/floor door vacuum control motor. 7. Remove the electronic actuator. 1. Disconnect the electronic actuator electrical connector. 2. Remove the three actuator screws. 3. Pull down to release the actuator shaft and remove the electronic actuator.