Home Tips & Tricks Starter Motor Service Manual 07 Ford Truck F 150 4WD

Starter Motor Service Manual 07 Ford Truck F 150 4WD

88
Download Starter Motor Service Manual 07 Ford Truck F 150 4WD – Removal and Installation WARNING: When carrying out maintenance on the starting system be aware that the heavy gauge leads are connected directly to the battery. Make sure the protective caps are in place when maintenance is completed. Failure to follow these instructions may result in personal injury. 1. With the vehicle in NEUTRAL, position it on a hoist. 2. Disconnect the battery ground cable. 3. Remove the nut and disconnect the starter solenoid S-terminal eyelet. To install, tighten to 6 Nm (53 lb-in) . 4. Remove the nut and disconnect the starter solenoid B-terminal eyelet. To install, tighten to 12 Nm (9 lb-ft). 5. Remove the nut and disconnect the starter motor ground cable eyelet. To install, tighten to 20 Nm (15 lb-ft) . 6. Remove the stud bolt, the bolts and the starter motor. To install, tighten to 25 Nm (18 lb-ft) . 7. NOTE: Tighten the upper bolt before tightening the lower fasteners. To install, reverse the removal procedure.