Home Tips & Tricks 2006 Honda Civic DOOR PANEL REMOVAL/ INSTALLATION

2006 Honda Civic DOOR PANEL REMOVAL/ INSTALLATION

54
Download Special Tools Required KTC trim tool set SOJATP2014 Trim pad remover, Snap-on A177A, or equivalent, commercially available. 2-DOOR NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when prying components. 1. If applicable, remove the regulator handle (A) by pulling the clip (B) out with a wire hook (C). 2. Remove the inner handle (A). Take care not to scratch the door panel. 1 Pry out on the upper portion of the cover (B) to release the hooks (C, D), then remove the cover. 2 Remove the screws. 3 Pull the inner handle forward and out half-way to release the hook (E). 4 Disconnect the inner handle rod (F) and power door lock switch connector (G) (driver’s side for some models). 3. Remove the switch panel (A) (power window model) or the pull pocket (B) (manual window model). 1 Using a trim tool, pry the cap (C), then remove the screw (D). 2 Pry out the panel or pocket to release the clips (E). 3 Release the clip (F) by pulling the cover or pocket forward. 4 Power window model: Disconnect the power window switch connector (G). 5. Remove the mirror mount cover (see step 2 on 2-DOOR ).