Download DASH DISASSEMBLY HONDA PILOT 2009-11 A C 1 D isconnect the negative battery terminal to prevent an accidental short circuit. 1 Unclip and remove the right a/c vent panel. (Figure A) 3 Remove the (2) Phillips screwssecur- ing the pocket below the radio then unclip and remove the pocket. (Figure B) 4 Remove (4) Phillips screws securing the radio, Unplug and remove the radio. (Figure C) 5 Unclip and remove the left a/c vent panel surrounding the shifter. (Figure A) 99-7876 DASH DISASSEMBLY HONDA PILOT 2009-11 2 Remove (4) Phillips screws securing the factory climate control. Unplug and remove factory climate control. NOTE: Retain (4) Phillips screws and climate control for reuse in Kit Assembly. (Figure E) 7 Remove the (6) screws retaining the (3) clip assemblies at the top edge of the factory radio/climate control assembly. Retain screws and clip assemblies for reuse. (Figure D) 6 KIT PREPARATION REAR VIEW RADIO HOUSING A B HONDA PILOT 2009-11 * Note: Refer also to the instructions included with the aftermarket radio. Attach the (3) clips removed in step 6 of the disassembly to the 99-7876 radio housing using the factory hardware. (Figure B) 2 Cut and remove support strut on radio housing. (Figure A) 1 Continue to kit assembly. KIT ASSEMBLY ISO MOUNT RADIO PROVISION WITH POCKET * Note: Refer also to the instructions included with the aftermarket radio.