Home Tips & Tricks Audi A8 D3 Sony HCB-30 Bluetooth Kit Installation Checklist

Audi A8 D3 Sony HCB-30 Bluetooth Kit Installation Checklist

82
Download kit Torx T-35 screwdriver Soldering iron Solder Heat gun or other heat source to heat shrink tubing Drill with 3/8″ bit Small wire cutters Wire strippers that go down to 20 gage wire Electrical Tape Drop or Flash Light Hanger for pulling wire Step Description Completed (check) 1 Place Telematics box in Service Mode. 2 Remove Fuse SB13. 3 Remove driver’s side trim and Telematics box from under carpet. 4 Disconnect wiring from Telematics box. Drill hole for wiring harness. Modify six connections on the 42 pin connector. 5 Install cover on 42 pin connector, plug into Telematics box, install Fuse SB13. Plug all components into HCB- 30 brain box, turn on ignition and test. 6 Mount HCB-30 brain box, run wiring. 7 Replace Telematics box, replace carpet. 8 Mount and route the microphone and wire. 9 Mount and route the touch pad and wire. 10 Take Telematics box out of Service Mode. 11 Replace all trim removed. 12 Remove the cover below center armrest. 13 Pull carpet down on passenger side. 14 Route phone cradle power wires and antenna wire. 15 Make up connections. 16 Trim carpet to allow wires to pass through carpet strip. 17 Reinstall carpet strip and carpet. 18 Mount Kuda base.