Download NOTE: Use the suitable device from the KTC trim instrument set to avoid harm when prying components. 1. If relevant, take away the regulator deal with (A) by pulling the clip (B) out with a wire hook (C). 2. Take away the inner deal with (A). Take care not to scratch the door panel. -1 Pry out on the higher portion of the duvet (B) to launch the hooks (C, D), then take away the cover. -2 Remove the screws. -3 Pull the internal handle ahead and out half-solution to release the hook (E). -4 Disconnect the inner deal with rod (F) and energy door lock switch connector (G) (driver’s facet for some fashions).3. Take away the switch panel (A) (power window model) or the pull pocket (B) (guide window mannequin). -1 Using a trim software, pry the cap (C), then take away the screw (D).-2 Pry out the panel or pocket to launch the clips (E). -3 Release the clip (F) by pulling the cover or pocket forward. 4. Take away the screws (H) securing the door panel. 5. Take away the mirror mount cover.6. Release the clips that hold the door panel (A) with a commercially obtainable trim pad remover (B), then take away the door panel by pulling it upward.