Home Tips & Tricks 2002 Nissan Maxima SE DRIVER’S POWER SEAT WILL NOT MOVE FORWARD OR...

2002 Nissan Maxima SE DRIVER’S POWER SEAT WILL NOT MOVE FORWARD OR BACKWARD

60
Download 1. Remove the top screw only from the RH & LH side finishers (see Fig. 5 ). If equipped, remove both screws and finisher from the front edge of the seat (see Fig. 5 ). Fig. 5: Removing Finisher Screws & Front Finisher 2. Disconnect the seat sub-harness connector (to slide motor – see Fig. 6 ). Remove M8 (12mm head) bolt from both sides of the seat frame, located to the sides of the front edge of seat (see Fig. 6 ). Then, remove six nuts and two base plates on both sides, located at the top of the seat frame, to release the gear boxes (see Fig. 6 ). Fig. 6: Disconnecting Connector & Releasing Gear Boxes 3. Slide both of the seat rails back to the rear position (towards the seat back) and remove the worm gears, flexible wire, motor, and gear boxes, all as one unit, from the seat adjuster assembly (see Fig. 7 ).Fig. 7: Removing Gears, Wire, Motor & Gear Boxes 4. Remove the flexible wire from the gear boxes. To release the flexible wire from the motor end, pull up on the tab using a flat blade screwdriver or equivalent (see Fig. 8 ).