Download RADIO REMOVAL: 1. Carefully pry out on radio/dash bezel and unsnap to remove. CAUTION: PASSENGER AIRBAG SWITCH DOES NOT UNPLUG. 2. Insert DIN Removal Tools to release Factory Stereo, unplug all electrical connectors, and remove radio. FD1325 KIT PREPARATION 1. Screw in top brackets “L” and “R” to the back of the kit panel as shown in illustrations “A” with the hardware provided. 2. Remove the (2) top screws from the factory climate /vent control panel. 3. Snap the installation kit into the radio opening with screw holes on the bottom tabs and over (2) top screw holes for the Factory Climate/Vent control panel (See illustration “B”). 4. Reinstall the (2) top screws for the Factory Climate/Vent control panel. STEREO INSTALLATION: 1. See illustration “A” for kit assembly with DIN stereos. 2. Be sure to attach rear support bracket provided in the installation kit to the back as shown in illustrations “A”. 3. Connecting the stereo to the factory wiring as directed in the stereo’s owners manual. Scosche recommend the use of an FD02/FD16 connector set when connecting to the factory wiring.