Home Tips & Tricks Ford F-150 INSTALLATION INSTRUCTIONS REAR STABILIZER BAR

Ford F-150 INSTALLATION INSTRUCTIONS REAR STABILIZER BAR

62
Download 1. Install the D-shaped poly bushings on the flat areas of the sway bar. Between the hump and the arms of the sway bar. When the sway bar is mounted the hump should tilt slightly downward. 2. Disconnect vent tube and remove bolt. Place thick washer under brake tee as shown in picture (2). Reinstall bolt and connect vent tube. 3. Position the U-bolts on the axle tubes just inside of the shock mounts. The threads should be pointing downward. Make sure that the U-bolts are under any brake lines, wires or hoses on the axle to avoid pinching or crushing when the U-bolts are tight- ened. 4. Install the U-plates over the D-bushings on the sway bar. Install the saddle brackets on the U-bolts that are on axle tubes. Attach the U-plates to the U-bolts using the 1/2” hex nuts and the flat washers that are provided. Leave loose at this time to allow for adjustment. 5. Rotate the sway bar on the axle tubes and adjust side to side so that the sway bar is as centered as possible.