Home Tips & Tricks TOW BAR M-348 FOR MITSUBISHI PAJERO LWB FITTING AND OPERATION MANUAL

TOW BAR M-348 FOR MITSUBISHI PAJERO LWB FITTING AND OPERATION MANUAL

52
Download Follow the general directions in order to fit M-348 tow bar properly: 1.Rear bumper removing and cutting is not required. 2.Remove double towing lug from chassis rail (will no longer be used). 3.Remove plastic shield at the right wheel arch. 4.Loosen exhaust silencer. 5.Remove plastic grille under air conditioner. 6.Remove air conditioner. 7.Put (3) to the inside of the right chassis rail and tight loosely using (11) (fitting from the outside of the chassis rail) with (8), (13) and (9) (fitting from the inside of the support) with (15) and (13). 8.Put (4) to the inside of the left chassis rail and follow directions similarly as in point 7. 9.Put (5) and (6) to the right and left chassis rail from the downside and tight loosely using (9) with (15) and (13). Attach (5) and (6) with (3) and (4) using (10) with (7) (fitting from the outside) and (15), (13) and (17) (fitting from the outside). 10.Insert (1) between (3) and (4) and tight loosely using (10) with (15), (13) and (17). 11.Attach (2) to the tow ball holder using (12) with (16), (14) and (18). 12.Tighten all nuts and bolts to the torque staked in the table. 13.Refit all elements that were removed (points 2-5). Obeying this instruction assures correct montage and the tow bar operating in a Mitsubishi Pajero LWB. After assembling of the tow bar M-348 you have to get entry in cars registration book in a quality control station . CAUTION :