Download Repair Procedure Removal: 1. Disengage the 4 claws from the sunvisor plastic bracket cover. 2. Remove the plastic bracket cover and set aside for later installation. Figure 2. Repair Procedure (Continued) Removal: (Continued) 3. Carefully pull straight down on the Sunvisor sub-assembly and remove it from the opening in the metal roof panel. NOTE If the attaching clips remain in the metal roof panel, pinch the clip tabs together and rotate away from the connector as shown in Figure 3 (if equipped with a vanity light), then remove the clips and reinstall the clips back into the sunvisor bracket from the direction shown in Figure 4.Repair Procedure (Continued) Installation Procedure: 1. Partially install the bracket cover into the sunvisor bracket making sure both temporary set claws are engaged as shown in Figure 5. NOTE Make sure to ONLY partially install the bracket cover into the bracket during installation, because damage to the clip, sunvisor mount or roof sheet metal tabs may occur if the bracket cover is fully in the sunvisor bracket.