Download STEP 1. Begin by removing the ashtray by pushing on the silver tab and pulling out. Set the ashtray aside. Next, remove the climate con- trol/radio trim bezel by grasping it inside the ashtray cavity and pulling toward you. Slowly continue working your way around the bezel. A total of seven clips will be released, two on the right, three on the left, and two above the radio. It is not necessary to disconnect the wiring attached to the bezel. Let the bezel hang to the left side. NOTE: Use protective cloth in between the hanging bezel and dash to prevent scratching. STEP 2. Using a 10mm socket & driver and a #1 Phillips screwdriver, locate and remove one Phillips and one 10mm factory screws to the right and slightly above climate control. Set the screws aside. Place Pro.Fit VSMTM over the screw holes. Replace the screws and tighten. STEP 3. Re-install the trim bezel. Attach the phone holder onto the Pro.Fit VSMTM.