Home Tips & Tricks Mud Guards Service Manual '11 Toyota Matrix

Mud Guards Service Manual '11 Toyota Matrix

47
Download Removal and Installation 1. Clean Front Mounting Area (a) Clean and degrease front body panel where mudguard is to be located with a clean, dry lint free cloth and 3M™ Prep Solvent – 70. (b) When cleaning with 3M™ Prep Solvent-70 follow the manufacturer’s directions. Do not allow cleaner to air dry. 2. Hardware Removal (a) Remove existing screw location A and discard. (Fig. 2-1). (b) Remove push pin location B and discard. (Fig. 2-1). 3. Installation of Front Mudguard (a) Mount mudguard on body panel and install supplied push pin in location B, while holding part up and tight against body. (Fig. 3-1). (b) Install supplied #14 screw (Truss) in location A and D while holding part tight against body. (Fig 3-1). (c) Drill 2.7mm (7/64”) center pilot hole in location C, while holding part tight against body. (Fig 3-2) (d) Install supplied #14 screw (Truss) in location C, while holding part tight against body. (Fig 3-2) DO NOT OVERTIGHTEN 4. Clean Rear Mounting Area (1) Clean and degrease rear bumper panel where mudguard is to be located with a clean, dry lint free cloth and 3M™ Prep Solvent-70. (2) When cleaning with 3MTM Prep Solvent-70 follow the manufacturer’s directions. Do not allow cleaner to air dry.