Download Center Console Service Manual ’09 Honda Accord – Removal and Installation 1. M/T model: Remove the shift knob (A). -1 Lower the shift lever boot (B) to release the hooks (C) from the knob. 2. Detach the clips (A, B) by pulling the center console front panel (C) up. If equipped, disconnect the seat heater switch connectors (D). 3. Pry up on the right of the console pocket (A) with a trim tool, and detach the clips, then remove the pocket. 4. Remove the screws (A), detach the clips (B) and hook (C) by pulling the center holder (D) up, and disconnect the front accessory power socket connector (E). 5. Detach the clips (A, B) by pulling the center console rear panel (C) up. 6. Remove the center console (A). -1 Open the console box lid (B) then remove the console mat (C). -2 If equipped, disconnect the rear accessory power socket connector (D), and detach the clip (E). -3 Remove the screws (F, G), then pull the rear portion of the console up to release the hooks (H), then remove it. 7. Install the console in the reverse order of removal, and check if the clip is damaged or stress-whitened, and if necessary, replace it with new one.