Home Tips & Tricks Chevrolet 1994 Corvette Window Regulator and Motor installations

Chevrolet 1994 Corvette Window Regulator and Motor installations

58
Download See Determine 1 1. Take away the door trim panel and water deflector. 2. Take away the window, as outlined earlier in this section. 3. Decrease the window regulator about three / then remove the bolts. 4. Detach the window regulator motor electrical connector. 5. Take away the window regulator from the door by rotating the meeting counterclockwise, then tilt the higher rear floor out from the door, rotate clockwise and elevate the regulator meeting out. of the way down. Matchmark the placement of the higher regulator mounting bolts, four Fig. Fig. 1: Window regulator and motor mounting-1996 proven, others similar To put in: 6. Position the regulator assembly in the door. 7. Begin threading the upper and lower regulator mounting bolts, align the upper bolts with the matchmark made during removing, then tighten the bolts to 84 inch lbs. (9.5 Nm). 8. Attach the regulator motor electrical connector. 9. Set up the window, as outlined earlier in this section. 10. Instlal the water deflector and door trim panel.