Download 1. Remove the battery (10655). For additional information, refer to Battery. 2. Remove the battery junction box (BJB) cover and remove the attachment nut securing the positive cable. 3. Remove the negative cable bolt. 4. Remove the harness clips from the cable in the luggage compartment. 5. Remove the rear seat cushion. 6. Remove the upper RH B-pillar trim panel. For additional information, refer to Section 501-05. 7. NOTE: LH shown, RH similar Remove the lower RH B-pillar trim cover and scuff plate screws . 8. NOTE: LH shown, RH similar Remove the RH front and rear scuff plates. 9. NOTE: LH shown, RH similar Remove the RH A-pillar lower trim panel and position aside the carpet to expose battery cable. 10. Remove the retaining tie straps and detach the cable forward past the rear seatback into the passenger compartment. 11. Remove the cable attachment cover and the nut at the dash through-bolt and remove the cable. 12. In the engine compartment at the dash panel, remove the protective cover and the nut. 13. Remove the bolt at the body.