Home Tips & Tricks 1994 Lincoln Continental Electronic Instrument Cluster (EIC) Removal and Installation

1994 Lincoln Continental Electronic Instrument Cluster (EIC) Removal and Installation

51
Download If the actual vehicle mileage cannot be verified, the service center will supply a speedometer/odometer module with the odometer display preset to zero (”0″) miles and the service odometer segment (”s”) illuminated in the vicinity of the odometer display. In addition, an odometer mileage sticker is supplied with the replacement odometer. This sticker must display the estimated vehicle mileage and is to be affixed to the driver’s door. 1. Disconnect battery ground cable. 2. Position vehicle on a flat surface to prevent movement when shift control selector lever is out of position. 3. Turn ignition switch to unlock shift control selector lever and move lever down from front of EIC. 4. Tilt steering column down as far as possible. 5. Remove RH and LH instrument panel moulding (046A63) by pulling upward to unsnap two clips. Disconnect electrical connectors. Set instrument panel mouldings aside. 6. Remove five Torx® screws below instrument cluster that retain instrument panel finish panel (044D70) applique. 7. Unsnap instrument panel finish panel applique along top and pull instrument panel finish panel applique away from instrument panel (04320). 8. Disconnect switch assembly electrical connectors. Set instrument panel finish panel applique aside.