Home Tips & Tricks 1996 Ford Windstar Mirror Power Outside Rear View Removal and Installation

1996 Ford Windstar Mirror Power Outside Rear View Removal and Installation

73
Download 1. Remove the front door trim panel (23942). Refer to Section 01-05. Peel back the water shield if necessary to gain access to the mirror wiring connector. 2. Disconnect the wiring connector. Remove rear view mirror mounting hole cover (17K709) located above the front door trim panel (inside window sail cover) by using a flat blade screwdriver to carefully pry off. 3. Remove the three nuts retaining the outside rear view mirror (17682) to the front door (20124). 4. Pull outside rear view mirror away from the front door while guiding the wiring out of the front door. 5. To install, reverse Removal procedure. Tighten nuts to 6-8 Nm (54-70 lb-in). Glass, Outside Mirror Removal NOTE: Power mirror and manual mirror glass replacement procedure ar similar. 1. Push in on the bottom of the glass until it stops. 2. Protect the mirror body with a rag or similar material at the top and insert a flat blade screwdriver between the mirror body and glass. 3. Pry on the glass until it snaps loose from motor assembly. Disconnect the heater wires from the glass, if equipped.