Download NOTE: The following removal and installation procedures apply to all original equipment instrument panel (04320) mounted audio units. 1. Disconnect the battery ground cable (14301). For additional information, refer toSection 414-01. 2. Remove the center instrument panel finish panel. 1. Rotate the center instrument panel finish panel vents inward. 2. Through the vent openings, grasp the center instrument panel finish panel and pull outward. 3. Remove the center instrument panel finish panel. Disconnect the electrical connectors. 3. Using the special tool, pull out the audio unit. 4. Disconnect the radio antenna lead-in cable and the radio electrical connectors. 5. To install, reverse the removal procedure.