Home Tips & Tricks 2000 Ford F-150 Temperature Blend Door Actuator REMOVAL AND INSTALLATION

2000 Ford F-150 Temperature Blend Door Actuator REMOVAL AND INSTALLATION

26
Download Temperature Blend Door Actuator Removal All vehicles 1. Depower the supplemental restraint system (SRS). For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in Section 501-20B. 2. Remove the floor duct panel. Remove the pin-type retainers and release the expander clip. 3. Remove the RH instrument panel brake. 1. Remove the nut. 2. Remove the bolt. 3. Remove the brace. 4. Remove the LH instrument panel lower nut and position the brace aside. 5. Disconnect the restraints control module (RCM) electrical connector. 6. Remove the RCM and bracket assembly. 1. Remove the bracket retaining bolts. 2. Remove the RCM and bracket assembly. Vehicles equipped with rear airflow duct 7. Cut the rear seat airflow duct along both sides. Fold back carpet. Cut rear seat airflow duct. ? 8. Fold the air duct rearwards. All vehicles 9. Remove the floor duct. 1. Remove the two screws (one each side). 2. Remove the floor duct. 10. Remove the electronic blend door actuator. 1. Disconnect the connector. 2. Remove the screws.