Home Tips & Tricks AUDI A-2 CLAMPING ADAPTERS USERS MANUAL

AUDI A-2 CLAMPING ADAPTERS USERS MANUAL

31
Download Information on the use of anchoring stands (including their attachment to the EZ Liner mainframe) appears in the Universal Anchoring Systems Owners Manual. (Part No. 618740.) • Read all of these instructions prior to using the Audi A-2 Anchoring Accessory. • Clean jack tubes using one of the anchoring pins. (See Figure 1.) a. Insert a steel punch (or bar) through the 1/2 inch hole at end of pin and use it as a handle. b. Rotate the pin right and left as it is moved in and out of the jack tube hole. NOTE: Holes must be clean to allow for easy installation and removal of the anchoring assembly. IMPORTANT: DO NOTuse force to drive the pin into the jack tube. Using force to drive the pin into the hole may make it difficult (or impossible) to remove the pin. 1) Lift side of vehicle using suitable lifting device and place anchoring stands near front and rear corners of vehicle’s center section. 2) Position large angle support against back of anchoring stand and insert anchoring bolts through holes in support and through middle holes in anchoring stand.