Home Tips & Tricks 1998 Lincoln Town Car Electronic Blend Door Actuator REMOVAL AND INSTALLATION

1998 Lincoln Town Car Electronic Blend Door Actuator REMOVAL AND INSTALLATION

42
Download Actuator Electronic Blend Door Removal 1. Make sure the front wheels are in the straight-ahead position. 2. WARNING: To avoid the risk of serious personal injury, read and follow all warnings, notes and instructions in the deactivation procedure. Deactivate the supplemental restraint system (SRS). For additional information, refer to Section 501-20B. 3. Connect the battery ground cable. 4. Position the front seats rearward. 5. Disconnect the battery ground cable. 6. Through the glove compartment opening, remove the instrument panel support brace bolt. 7. Disconnect the aspirator hose from the housing. 8. Disconnect the RH bulkhead connector. 1. Loosen the bolt. 2. Disconnect the RH bulkhead connector. 9. Close the glove compartment door. 10. Remove the RH lower instrument panel insulator. 1. Disconnect the power point electrical connector. 2. Remove the courtesy lamp from the lamp socket. 3. Remove the RH lower instrument panel insulator. 11. Remove the tunnel brace trim cover. 12. Remove the instrument panel tunnel brace. 1. Remove the nuts. 2. Remove the brace. 13. Position the steering column brace aside. 1. Remove the nut. 2. Position the steering column brace aside. 14. Separate the intermediate shaft from the steering column shaft. 1. Remove and discard the pinch bolt.