Home Tips & Tricks 1994 Mazda Protege L4-1839cc 1.8l Sohc Axle Shaft

1994 Mazda Protege L4-1839cc 1.8l Sohc Axle Shaft

18

Download 1994 Mazda Protege L4-1839cc 1.8l Sohc Axle Shaft Removal And Installation REMOVAL / INSPECTION 1. Remove in the order indicated in the illustration, referring to the removal note. 2. Install in the reverse order of removal indicated in the illustration, referring to the installation note. 3. Fill the transaxle with the specified amount and type of ATF, and inspect for oil leakage. Separate the right-side drive shaft from the joint shaft by hammering on a brass or copper bar inserted between them. Joint Shaft (7) Pull the joint shaft straight out Installation Note Clip (8) 1. Install a new clip so that the opening is facing upwards. 2. Measure the outer diameter of the clip after installing, and replace the clip if it exceeds the specification. Outer diameter of 30 mm (1.181 inch) maximum. Joint Shaft (7) Tighten the bolts in the order shown to 43 – 61 Nm (32 – 45 ft. lbs.). Drive Shaft and Axle Component (6) 1. Push the drive shaft onto the joint shaft. 2. After installation, pull the front hub outward to verify that the drive shaft is securely held by the clip.