Home Tips & Tricks 1998 Dodge Durango Air Bag Service and Repair REMOVAL

1998 Dodge Durango Air Bag Service and Repair REMOVAL

120
Download Driver Side 1. Disconnect and isolate the battery negative cable. If the airbag has not been deployed, wait two minutes for the system capacitor to discharge before further service. Driver Side Airbag Module Remove/Install 2. From the underside of the steering wheel, remove the two screws that secure the driver side airbag module to the steering wheel. 3. Pull the airbag module away from the steering wheel far enough to access the wire harness connectors on the back of the airbag module. 4. Unplug the airbag module and horn switch wire harness connectors from the back of the airbag module. 5. Remove the driver side airbag module from the steering wheel. 6. If the airbag has been deployed, the clockspring must be replaced. See Clockspring in the Replacement for the procedures. 7. When installing the airbag module, connect the clockspring wire harness connector to the module by pressing straight in on the connector. Be certain that the connector is fully engaged by observing the latch arms on each side of the connector. When these arms move outward from the connector, the connector is latched. 8. Connect the horn switch wire harness connectors. 9. Install the airbag module in the steering wheel.