Download REMOVAL PROCEDURE The power antenna is serviced as a complete unit only, however an antenna (mast) which has been bent or broken can be replaced, rather than replacing the complete power antenna. 1. Using the socket (1) provided with the antenna (mast) service kit, remove the antenna mast nut (2). 2. Turn the ignition to the ACC or ON position. 3. Turn the radio ON to raise the power antenna. IMPORTANT: Prior to complete removal, note the orientation of the serrated side of the antenna mast plastic cable (5). The antenna mast plastic cable (5) will likely coil back once removed, take precautions to avoid grease splatter on the vehicle.