Home Tips & Tricks 1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation

1999 Ford Taurus Camshaft Position (CMP) Sensor SHO Removal Installation

156
Download Camshaft Position (CMP) Sensor SHO Removal 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove the engine appearance cover. For additional information, refer to Section 03-01C. 3. Disconnect engine control sensor wiring (12A581) from camshaft position sensor (CMP sensor) (6B288) . 4. Remove camshaft position sensor retaining bolt and remove camshaft position sensor from engine. Installation 1. Make sure camshaft position mounting sensor surface is clean and that camshaft position sensor O-ring is in proper location on camshaft position sensor . 2. CAUTION: Do not overtighten camshaft position sensor retaining bolt or damage to camshaft position sensor or engine mounting surface may occur. Position camshaft position sensor onto engine and install retaining bolt. Tighten retaining bolt to 8-12 Nm (71-106 lb-in). 3. Connect engine control sensor wiring to camshaft position sensor.