Home Tips & Tricks 2000 Volkswagen Cabrio Steering column assembly

2000 Volkswagen Cabrio Steering column assembly

129
Download 1. – Horn pad – Removing, Fig. 1 Horn plate – Removing, Fig. 2 50 ±10 Nm (37 ±7 ft lb) Steering wheel – Horn contact ring, Fig. 3 – Lubricate horn ring with universal grease Steering column switch securing screws Combination switch – Turn signal switch. -E2- – Headlight dimmer/flasher switch -E4- – Emergency flasher switch -E3- – Removing, Fig. 4 Windshield wiper/washer switch -E22- – Removing, Fig. 4 Upper steering column trim Lower steering column trim Steering column Support ring Steering lock housing securing bolt 2. – 3. – 4. – 5. – 6. – 7. – 8. 9. 10. 11. 12. – – – – – 2000 Volkswagen Cabrio L4-2.0L (ABA) – Shear bolt Steering lock housing – Removing and installing, refer to Steering and Suspension, Steering, Steering Column, Service and Repair Ignition/starter switch -D- – To remove, first remove steering lock housing, then remove securing screws Lock cylinder – Removing/installing, Fig. 5 Spring Clamping washer 13. – 14. – 15. – 16. – 17. – Fig. 1 Horn pad, removing WARNING! Vehicles with airbags, refer to Service Precautions Vehicles without airbag – Lift horn pad at bottom and pull from steering wheel in direction of arrow. – Remove horn wire. Fig. 2 Horn plate, removing – Remove wire connector from horn plate. – Disengage retaining lugs -arrows- and remove contact plate -A- from contact plate -B-. Note: The horn plate consists of two non insulated contact plates. Horn operates when the horn pad is pressed and plate -A- contacts plate -B- .