Download WARNING:Fuel line spills and leakage from the pressurized fuel system aredangerous. Fuel can ignite and cause serious injury or death anddamage. To prevent this, complete the following inspection with theengine stopped.1. Follow “BEFORE SERVICE PRECAUTION” before performing any workoperations to prevent fuel from spilling from the fuel system. (See BEFORESERVICE PRECAUTION.) 2. Disconnect the negative battery cable. 3. Disconnect the quick release connector (in the engine compartment). (SeeQUICK RELEASE CONNECTOR (FUEL SYSTEM)REMOVAL/INSTALLATION.)Turn the lever of the SST parallel to the hose as shown in the figure. 5. Insert the SST quick release connector into the fuel pipe until a click isheard. 6. Verify that the quick release connector is firmly connected by pulling it byhand. 7. Start the fuel pump using the following procedure:Using WDS or equivalent1. Connect the WDS or equivalent to the DLC-2. 2. Start the fuel pump using the “FP” simulation function.Not using WDS or equivalent1. Remove the fuel pump relay.