Home Tips & Tricks Chassis A960e Automatic Transmission '06 Toyota

Chassis A960e Automatic Transmission '06 Toyota

123

Download ATF Filling procedure using SST (09843-18040) When a large amount of ATF needs to be filled (i. e. after removal and installation of oil pan or torque converter), perform the procedure from step 1. When a small amount of ATF is required (i. e. removal and installation of oil cooler tube, repair of a minor oil leak), perform the procedure from step 7. 1) Raise the vehicle while keeping it level. 2) Remove the refill plug and overflow plug. 3) Fill the transmission with WS type ATF from the refill plug hole until it overflows from the overflow plug hole.  The fluid used to fill the transmission should be ATF WS. 4) Install the overflow plug. 5) Add the specified amount of ATF (specified amount is determined by the procedure that was performed) and install the refill plug. 6) Lower the vehicle. 7) Use the SST (09843-18040) to short the TC, OPB, and CG terminals of the DLC3 connector: 8) Start the engine and allow it to idle.  A/C switch must be turned off. 9) Move the shift lever from the P position to the S mode position and slowly select each gear S1 – S6. Then move the shift lever back to the P position. 10)Move the shift lever to the D position, and quickly move then back and forth between N and D (at least once every 1.5 seconds) for at least six seconds.